2004 MORBARK 4600XL

2004

7,470

Used

ELECTRIC HORIZONTAL GRINDER 2004 Morbark Model 4600XL Electric Wood Hog with fresh rebuild LOCATED ON THE CENTRAL COAST, CALIFORNIA *NOT LOCATED IN TULARE* Current hours 7,470 Rare find, ELECTRIC Morbark grinder, includes all Western plains electronics, building, discharge conveyor and 4600XL grinder. This unit is well taken care of and just had a major overhaul done on the hammermill, including new shaft, bearings, all side plates, drive belts and just installed a new feed floor. This unit is ready for its new home. Located on the Central Coast of CA, this unit is available to demo for its new owner. - Mill Drive with Dual 400 HP Electric Western Motors - Auxiliary Drive 150 HP Western Motor - Includes o Cross Belt Magnet o Brunnel Torque Limiter o Western Plains Electric Motor Control Center  10 x 10 insulated Skid Mounted Enclosure  (Total service is 1,400 amps)  800 Amp Main Breaker  600 Amp Main Breaker  Soft Tronics 400 HP Soft Start  Wye Delta 150 HP Soft Start  Additional 15KVA 480 V Transformer and attached breakers  1 – 2007 Morbark 4048 Radial Stacking Conveyor Rebuilt less than 100 hours ago, major overhaul on Hammermill including o New Shaft o New Bearings both sides o New Bearing housings o New Drum end plates o New Wedge clamps on both sides o New Rod locking plates o New Rods, hammers and inserts o New Insert holders o New 10 groove sheave o New Hood Wear Plates o New Side Wear Plates o New Anvil o New Left and Right-side base filler top o New Hydraulic Control valves for floor and yolk control o New Drive belts o Many new hydraulic hoses o All new parts were purchased through Pape using Morbark OEM parts o The feed floor was rebuilt with AR 40